INSTALLATION INSTRUCTIONS
for Wood Patio Doors with Exterior Trim or Nailing Fin (JII026)
5
SEAL DOOR FRAME (EXCLUDING INTEGRAL NAIL FIN)
Interior side up, apply a continuous bead of silicone sealant where the
trim/n meets the door frame.
APPLY DRIP CAP TO FINNED DOORS
1. With the exterior
face up, apply a
1/4" bead of silicone
across the header
as shown (do not
apply sealant to the
groove). Tap the
drip cap into the
groove with a wood
block.
5. Cut two pieces of
JELD-WEN self-
adhesive ashing 6"
wide by the sill pan
width + 3" long.
a. For continuous
slab landings
only, cut out
the inside
corner.
b. Adhere the
pieces of
ashing to the
inside corners.
Stretch ashing
as needed to
cover corners
and lay at.
6. Smooth gaps or
bubbles beneath
self-adhesive
ashing with a
J-roller (remove
and replace if
necessary).
7. Seal back corners of
sill pan with sealant.
8. For step-down
landings only, cut
plastic drain screen
to length of sill +
2" and staple 1/2"
below sill edge. The drain screen provides a path for air to dry any
incidental moisture in the rough opening.
End of Stud-Framed Wall Instructions continue with section 7 “PREPARE
PATIO DOOR.”
FOR RETROFIT INSTALLATIONS
After removing the old patio door, remove sufcient siding to expose at
least 9" of intact building wrap. If damaged, apply new building wrap
in a shiplap manner. Verify header and trimmer studs are structurally
sound.
PREPARE BUILDING WRAP
Verify these steps do
not void the building
wrap manufacturer’s
warranty.
1. Trim building wrap
ush with the
edges of the rough
opening.
2. At the head, slit
building wrap 6"
at 45°. Tape up as
shown.
3. Apply spray
adhesive/primer
to the sill pan
and surrounding
area. Follow
manufacturer’s
instructions
for application
methods.
4. Cut a piece of
JELD-WEN self-
adhesive ashing
the length of the
sill and apply over
the sill pan as shown. The bottom of the sill pan should be completely
covered by the self-adhesive ashing. For step down landings, fold
ashing down as shown. For continuous slabs, trim ush with rough
opening.
6
7
PREPARE STUD-FRAMED WALL
PREPARE PATIO DOOR
6"
Sill pan
width
3"
6"
Discard
(for
continuous
slab only)
Continuous Slab
Landing
Sill pan
width
3"
3"
Step-Down
Landing
Sill pan
width
3"
3"
Sealant
1"
1/2"
2. Inswing/outswing
doors will need
a strip of self-
adhesive ashing
applied over the
dead bolt hole on
the exterior side of
the frame as shown.
Groove
Dead bolt
hole
2"
2"
(6 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern