JELD-WEN 404266 Bedienerhandbuch PDF herunterladen

INSTALLATION INSTRUCTIONS

for Aluminum Windows without Nailing Fin (JII031)

GLOSSARY

Backer Rod (backing material)

A material (e.g. foam rod), placed into a joint primarily to control the

depth of the sealant.

Buck

A wood framework attached to the masonry inside a window or patio

door rough opening.

Finless Window

A window without a nailing n that is secured by fastening through the

head, sill and jambs. Finless windows may also be known as block frame

or box frame windows.

Flush Fin Window

A window without a nailing n that has a face ange (trim only). Flush

n windows may also be known as ange, stucco ange or Florida

ange windows..

Precast Sill

A pre-formed concrete block placed in a masonry/block wall to support

a window.

Shiplap

The layering method in which each layer overlaps the layer below it so

that water runs down the outside.

Weep Hole (weep channel)

The visible exit or entry part of a water drainage system used to drain

water out of a window.

Newer construction methods have led to an increase in air and water

tightness in buildings. This frequently leads to negative air pressure

inside the home, which can draw water through very small openings. Our

installation method creates an air seal on the interior, integrating the

window with the rough opening.

Thank you for selecting JELD-WEN products. Attached are JELD-WEN’s

recommended installation instructions for aluminum windows without a

nailing n (including nless, ush n and ange). Read these instructions

thoroughly before beginning. They are designed to work in most existing

applications, however; existing conditions may require changes to these

instructions. If changes are needed, they are made at the installer’s risk.

For installations other than indicated in these instructions, contact a

building professional.

Not all window types may be installed into every wall condition in all

areas. Consult your local building code ofcial for applicable building

codes and regulations. Local building code requirements supersede

recommended installation instructions.

Note! Installations where the sill is higher than 35 feet above ground

level, or any product installation into a wall condition not specically

addressed in these instructions, must be designed by an architect or

structural engineer.

Failure to install windows into square, level, and plumb openings could

result in denial of warranty claims for operational or performance

problems.

Note to Installer: Provide a copy of these instructions to the building

owner. By installing this product, you acknowledge the terms and

conditions of the limited warranty as part of the terms of the sale.

IMPORTANT INFORMATION & GLOSSARY

Estimated Install

Time for New

Construction

First Time: 4.0 hr.

Experienced: 2.5 hr.

Professional: 1.5 hr.

1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONSfor Aluminum Windows without Nailing Fin (JII031)GLOSSARYBacker Rod (backing material)A material (e.g. foam rod), placed into

Seite 2 - NEEDED MATERIALS & TOOLS

INSTALLATION INSTRUCTIONS for Aluminum Windows without Nailing Fin (JII031)2These instructions specically address:Installation of a ush •n window

Seite 3 - PREPARE MASONRY/BLOCK WALL

INSTALLATION INSTRUCTIONS for Aluminum Windows without Nailing Fin (JII031)3REMOVE PACKAGINGRemove shipping materials such as corner covers, shipping

Seite 4 - INSTALL WINDOW

INSTALLATION INSTRUCTIONS for Aluminum Windows without Nailing Fin (JII031)4PREPARE STUD-FRAMED WALL4FOR RETROFIT INSTALLATIONSAfter removing the old

Seite 5 - INSTALL WINDOW - CONTINUED

Kommentare zu diesen Handbüchern

Keine Kommentare

JELD-WEN 404266 Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Nein JELD-WEN 404266 herunter. JELD-WEN 404266 Instructions / Assembly Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein JELD-WEN 404266