JELD-WEN THDJW144401123 Bedienerhandbuch PDF herunterladen

INSTALLATION INSTRUCTIONS

for Vinyl Projecting Windows with Integral Nailing Fin (JII023)

OPEN STUD CONSTRUCTION

The wall

framing needs

to be covered

by backing

support before

the window can

be installed. The

window will be

mounted with

the nailing n

ush against the

applied backing

support.

This backing

support should

be a non water-

degradable,

thin (max. 1/8" thick) sheet material such as vinyl sheeting. Completely

surround the rough opening with the backing support as shown.

Backing support must be applied before building wrap.

GLOSSARY

Mull Joint

The joint where two or more window units are structurally joined

together.

Mulled Unit

Two or more window units structurally joined together.

Shiplap

The layering method in which each layer overlaps the layer below it so

that water runs down the outside.

Weep Hole (weep channel)

The visible exit or entry part of a water drainage system used to drain

water out of a window.

Newer construction methods have led to an increase in air and water

tightness in buildings. This frequently leads to negative air pressure

inside the home, which can draw water through very small openings.

Our installation method integrates the window with the weather

barrier (typically building wrap).

Thank you for selecting JELD-WEN products. Attached are

JELD-WEN’s recommended installation instructions for vinyl bay,

bow and garden windows which incorporate an integral nailing n.

While the use of these installation instructions is recommended,

installation in strict compliance with AAMA specications (2400-02)

is an alternate method of window installation. Use of the AAMA

specications (2400-02) will not affect application of the JELD-WEN

limited warranty.

Not all window types can be installed into every wall condition in all

areas. Consult your local building code ofcial for applicable building

codes and regulations. Local building code requirements supersede

recommended installation instructions.

Note! Installations where the sill is higher than 35 feet above ground

level, or any product installation into a wall condition not specically

addressed in these instructions, must be designed by an architect or

structural engineer.

Failure to install windows into square, level, and plumb openings could

result in denial of warranty claims for operational or performance

problems.

Note to Installer: Provide a copy of these instructions to the building

owner. By installing this product, you acknowledge the terms and

conditions of the limited warranty as part of the terms of sale.

IMPORTANT INFORMATION AND GLOSSARY

Estimated Install

Time for New

Construction

First Time: 2 hrs

Experienced: 1.5 hrs

Professional:

1 hr

8 4

7 5

This installation guide specically addresses sheathed wall and open-stud

construction. Windows without an integral head and seat board must be

placed on a structure that provides continuous support to the sill.

FULLY SHEATHED WALL CONSTRUCTION

The wall framing

is covered by

sheathing and

the window will

be mounted with

the nailing n

ush against the

sheathing.

ROUGH OPENINGS

Sheathed Wall

Trimmer

studs

Header

Sheathing

Sill

King

stud

Cripple studs

Open-Stud with Backing

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1

INSTALLATION INSTRUCTIONSfor Vinyl Projecting Windows with Integral Nailing Fin (JII023)OPEN STUD CONSTRUCTIONThe wall framing needs to be covered by

Seite 2 - SAFETY AND HANDLING

INSTALLATION INSTRUCTIONS for Vinyl Projecting Windows with Integral Nailing Fin (JII023)21REMOVE PACKAGING AND INSPECT WINDOWMATERIALSNote! Follow al

Seite 3 - PREPARE ROUGH OPENING

INSTALLATION INSTRUCTIONS for Vinyl Projecting Windows with Integral Nailing Fin (JII023)3FOR RETROFIT INSTALLATIONS1. Remove sufcient siding to expo

Seite 4 - INSTALL BAY/BOW WINDOW

INSTALLATION INSTRUCTIONS for Vinyl Projecting Windows with Integral Nailing Fin (JII023)4PREPARE SILL FOR BAY/BOW WINDOW4PREPARE/SHIM THE SILL1. Use

Seite 5 - FLASH BAY/BOW WINDOW

INSTALLATION INSTRUCTIONS for Vinyl Projecting Windows with Integral Nailing Fin (JII023)5APPLY THE SELF-ADHESIVE FLASHINGNote! Keep the edge of the s

Seite 6 - INSTALL GARDEN WINDOW

INSTALLATION INSTRUCTIONS for Vinyl Projecting Windows with Integral Nailing Fin (JII023)64. Press the adhesive section of the ashing onto outside se

Seite 7 - FLASH GARDEN WINDOW

INSTALLATION INSTRUCTIONS for Vinyl Projecting Windows with Integral Nailing Fin (JII023)7APPLY THE SELF-ADHESIVE FLASHINGNote! Keep the edge of the s

Seite 8

INSTALLATION INSTRUCTIONS for Vinyl Projecting Windows with Integral Nailing Fin (JII023)8AFTER INSTALLATION1. Adjust window for best operation.2. Ins

Kommentare zu diesen Handbüchern

Keine Kommentare

JELD-WEN THDJW144401123 Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Grasschneider JELD-WEN THDJW144401123 herunter. JELD-WEN THDJW144401123 Instructions / Assembly Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern